Setting Program Start Times; Selecting The Days To Water - Irritrol Total Control Guia Del Usuario

SETTING PROGRAM START TIME(S)
This procedure is used to set the watering cycle start time(s) for each program. A maximum
of 16 start times can be allocated to the four programs in any manner. Each start time will
initiate a sequential watering cycle of all stations with an assigned run time in the program.
NOTE:
When 16 start times have been allocated, the display will show none remaining
when attempting to assign additional start times.
To set program cycle start time(s):
1. Turn the function dial to the
2. Select Program
+
3. Use the and/or
NOTE:
To remove a start time, adjust the time to display off (located between
11:59 p.m. and 12:00 a.m.).
NEXT
4. Press the
5. Repeat steps 2 through 4 for each program as necessary.
NOTE:
The Total Control will operate one watering cycle in a program at a time. If a start
time occurs while a watering cycle is in progress, the start time will be delayed until the
previous cycle is fi nished (this is called "start time stacking"). If the watering cycle extends
past midnight into the next day, the cycle will continue operating until fi nished. However,
if a watering cycle has been delayed until after midnight into a non-watering day, the
watering cycle will not occur.

SELECTING THE DAYS TO WATER

Several watering day scheduling options are available. Each watering program can utilize
any one of the following schedules:
• Days of the week
Use this type of schedule to water on specifi c days of the week. The days are displayed as
three-letter abbreviations. For example, Sunday is sun, Monday is mon, etc. Only the days
you select to water will remain on the display.
• Odd Dates or Even Dates
To select every odd or even numbered calendar dates, use this option. Because the 31st and
the 1st are both odd numbered dates, the 31st is automatically removed from the schedule.
This watering day option also enables selected days of the week to be removed from the
schedule.
• Day Interval
Selecting water days by Day Interval enables a specifi c number of days between watering
to be selected. For example, selecting a 1-day Interval schedules watering for every day. A
2-day interval schedules watering for every other day. A 30-day interval is the maximum
interval frequency, which provides watering once every 30 days.
12
Start Times
A B C D
, , or with the Program switch.
–
buttons to display the start time.
button to assign another start time to the program.
position.