Specifications; Environmental Operating Conditions; Instructions For Use; Special Considerations - 3M Attest 490M Manual Del Usuario

SPECIFICATIONS

Power Supply Specifications
Power supply Operating Condition
Voltage Range 100-240
Frequency 50/60
Current 0�6

Environmental Operating Conditions

Environmental Condition Operating Condition
Altitude 3000 (max)
Operating Temperature 16 – 35
Storage Temperature -10 to 50
Operating Relative Humidity 20-80 (non-condensing)
Voltage Range 12
Frequency DC
Current 1�2
Installation/Over Voltage Category II
Pollution Degree 2
Unit Dimensions
Width - 15�5 cm
Height - 8�25 cm
Depth - 5�25 cm
4
INSTRUCTIONS FOR USE – Initial Set‑up
Choose Location
Units
Place 3M™ Attest™ Mini Auto-reader 490M on a firm level surface away from
Volts AC sunlight and incandescent light�
Hertz
Select & Install Correct Power Plug
Amps
The 3M™ Attest™ Mini Auto-reader 490M power supply comes with multiple
blade configurations� Install the blade configuration appropriate for your country
into the power supply� Connect the power supply to the power receptacle located
Units
on the back of the 3M™ Attest™ Mini Auto-reader 490M and then plug into an
Meters
appropriate AC grounded outlet�
ºC
The power supply plug serves as the electrical supply source disconnecting
device� Do not position any equipment around the power supply which makes it
ºC
difficult to unplug the power supply�
%
The bootloader (B X�X�X) and firmware (V X�X�X) versions are briefly sequentially
Volts DC
displayed when the 3M™ Attest™ Mini Auto-reader 490M is powered on�
Amps
WARNING:
• Do not place the instrument in environment exposed to sunlight or strong
incandescent light�
• Do not place instrument close to any device that emits a strong
electro-magnetic field�
• Do not use on a vibrating surface�
Wait 30 Minutes Before Using
Once plugged in, allow a 30 minute warm-up period before placing biological
indicators into the incubation wells� The C1 caution code will disappear when
proper incubation temperature is reached�

Special Considerations

It is recommended that the unit be left on to eliminate warm‑up periods.
The unit may be unplugged when it is anticipated that it will not be used for an
extended period�
WARNING: Use only the power supply specified for this product and
certified for the country of use�