Error Messages; Care And Maintenance - Rothenberger ROWELD P 250/8 B Instrucciones De Uso

Pressing on the corresponding display field brings up the entry form. The data can be deleted
with DEL and reentered. These data are later placed into the log.
3.8

Error messages

Touch PC and log:
Error message
Code 1
Code 2
Code 4
Code 64
Code 128
Code 256
Code 512
Code 2048
Code 4096
Code 131072
Controls:
Error message
SER
ERR1
PE-2
ERR5
HE-1
HE-0
HE-2
4

Care and maintenance

To ensure that the welding machine functions properly, observe the following maintenance
recommendations:
• The guide rods must be kept free of dirt and grime. Replace guide rods whenever surface
shows signs of erosion or damage, otherwise hydraulic system may loose pressure.
• To achieve perfect welding results, it is essential to keep the heating plate clean. If the surface
is damaged or shows signs of erosion, the surface must be recoated or replaced. Material
residues on the heating plate surface reduces the non-sticking properties of the coating.
Remove all residues with non-linting paper and alcohol (heating plate must be cool!).
Description
Equalization pressure too high
Equalization pressure too low
Warm-up pressure too high
Changeover time too long
Pressure dissipation time too long
Joining pressure too high
Joining pressure too low
Heating element too cold
Interruption by operator
Heating element too hot
Description
Service date reached, service
due
Absolute pressure not
reached
Pressure sensor -24V
defective
Oil temperature 70°C – Stop!
Heating element not
connected, sensor break
Heating element too hot
Heating element too cold
ENGLISH
Troubleshooting
Have service performed
Check oil level, check pressure sensor,
defective valve, defective motor
Replace pressure sensor
Wait until the oil temperature is below
50°C
Replace the sensor
Remeasure temperature, check
settings, replace sensor
Remeasure temperature, check
settings, replace sensor
53