HP LaserJet Pro CP1020 Serie Guía De Introducción

Color LaserJet Pro
CP1020 Series
Getting Started Guide
IMPORTANT:
Steps 1 - 3
Follow on
the printer hardware setup
poster, then continue
with Step 4 to the right.
Wired (Ethernet) network connection
(CP1025nw model only)
Use a standard network cable.
1. Connect the network cable to the printer and to the network. Wait a few
minutes for the printer to acquire a network address.
2. Print a Network Configuration Page to identify the printer IP address.
On the control panel, press and hold the Cancel
ready light starts to blink, and then release the button. The test
page prints. Note the IP address for use during software installation.
Example IP address: 192.168.0.1
To manually configure the IP address, see
IP address."
3. Continue with "5. Locate or download the software installation files."
NOTE: During software installation, select the option to Configure to
print over the Network.
Manually configure the IP address
For information on how to manually configure the IP address, see the printer
User Guide www.hp.com/support/ljcp1020series.
www.hp.com/support/ljcp1020series
4. Select a connection method and prepare
for software installation
USB connection directly between the
printer and the computer
Use an A-to-B type USB cable.
Windows
1. For Windows 7 or lower, do not connect the USB cable before installing the software.
The installation process prompts to connect the cable at the appropriate time. If the
cable is already connected, restart the printer when installation prompts to connect
the cable.
2. Continue with "5. Locate or download the software installation files."
NOTE: During software installation, select the option to Configure to print using USB.
Mac
1. Connect the USB cable between the computer and the printer before installing
the software.
2. Continue with "5. Locate or download the software installation files."
button until the
"Manually configure the
www.register.hp.com
Built-in wireless network connection
(CP1025nw model only)
1. To connect the printer to a wireless (Wi-Fi) network, make sure that
the printer, access point, and computer are all turned on, and that the
computer is connected to the wireless network.
2. A USB cable will be required.
3. Disconnect any USB or Ethernet cable that is connected to the printer.
4. To print from a computer, continue to
software installation files."
continue with "7. Mobile and wireless printing (optional)."
NOTE: During software installation, select the option to Configure to print
over the Wireless Network.
1
2
English .............. 1
Français ............ 4
Español ............. 7
Português ....... 10
.............. 13
"5. Locate or download the
To print from a phone or tablet only,