Horizon Fitness CT9.1 Manual Del Propietário página 10

ASSEMBLY STEp 1
HARdWARE bAG 1 CONTENTS :
BOLT (A)
20 mm
Qty: 6
CONSOLE MAST
MAIN
FRAME
BOOT
BOLTS (A)
SPRING
WASHERS (B)
ARC WASHERS (C)
MAIN FRAME BRACKET
10
SPRING WASHER (B) ARC WASHER (C)
8.2 mm 8.2 mm
Qty: 6 Qty: 6
LEAD WIRE
CONSOLE CABLE
Cut the yellow banding straps and lift the
A
running deck upward to remove all contents
from underneath the running deck.
Open HARdWARE bAG 1.
B
Slide MAIN fRAME bOOT up CONSOlE
C
MAST. Place RIGHT CONSOlE MAST over
MAIN fRAME bRACkET.
Pull lEAd WIRE through RIGHT CONSOlE
D
MAST. After pulling the lEAd WIRE through
the mast, the top of the CONSOlE CAblE
should be located at the top of the mast. Detach
and discard lEAd WIRE.
NOTE: Do not pinch CONSOlE CAblE when
placing the mast onto the MAIN fRAME
bRACkET.
Attach CONSOlE MAST to MAIN fRAME
E
bRACkET using 3 bOlTS (A), 3 SpRING
WASHERS (b) and 3 ARC WASHERS (C).
Slide MAIN fRAME bOOT down over MAIN
F
fRAME bRACkET.
Repeat steps D–F on other side.
g