Care And Maintenance - Bresser BIOLUX NV Instrucciones De Uso

12.3. The Photomizer Pro Software
(Bresser Edition)
If you need help in the „Photomizer"
programme click „?" and then „Open help".
If you need further assistance please visit the
maker's home page at www.photomizer.net

Care and maintenance

Separate the device from the power supply
before cleaning (remove plug)!
Only use a dry cloth to clean the exterior of
the device.
nOTe:
Do not use any cleaning
fluid to avoid damaging the
electronics.
Clean the lenses (eyepiece and/or lens) with a
soft and lint-free cloth only (e.g. microfibre).
nOTe:
Do not apply excess pressure
to the cloth so as to avoid
scratching the lenses.
To remove more stubborn dirt, moisten the
cleaning cloth with an eyeglass-cleaning
solution and wipe the lenses gently.
24
Protect the device from dust and moisture!
After use - in particular in situations of high
humidity - let the device acclimatize for a short
period of time, so that the residual moisture
can dissipate. Remove the dust cover and
store it in the included bag.
Troubleshooting
error solution
No picture visible switch light on
put condenser lens
in place
adjust focus
Picture flickers if necessary,
while viewing adjust resolution of the
with PC eyepiece video graphics board
Software installation confirm by
reports clicking "OK"
"not XP approved"
Specifications
system requirements for pC eyepiece
Minimum system requirements: PC with an
Intel Pentium IV processor or higher; Windows
XP with Service Pack 3*, Windows Vista
(32/64Bit) with Service Pack 2* or Windows
7 (32/64Bit) with Service Pack 1*; .NET
Framework 4.0*; min. 1024 MB RAM (64Bit
= 2048 MB); min. 500 MB free hard drive
space; free USB port; CD/DVD/BD drive.
*available for free via Windows Update
(Internet connection needed)