Power Sources; House Current (For All Models) - Sony HR Trinitron PVM-8045Q Manual De Instrucciones

Power Sources

House Current (for all models)

Connect the supplied AC power cord to the AC IN
socket and to a wall outlet.
to AC IN
To connect an AC power cord securely with AC plug holders.
1
AC IN socket
AC plug holder A
1
Remove the AC IN socket screws and then use
them to attach the AC plug holder A (supplied) to
the AC IN socket.
2
Plug the power cord to the AC IN sokcet. Then,
attach the supplied AC plug holder B on top of the
AC power cord.
Rechargeable Battery (PVM-8045Q/8042Q only)
The monitor can operate with one or two battery packs.
For extended use, two battery packs are recommended.
EJECT
buttons
NP-1B
(not supplied)
10
(US)
For the PVM-8045Q/8042Q
When the AC power cord is plugged into the AC IN
socket, the battery pack (if installed) or the AC power
adaptor (if connected) is automatically disconnected.
to a wall outlet
2
AC power plug
3
To remove the AC power cord
Pull out AC plug holder B by squeezing the left and
right sides.
To remove the battery pack, press the EJECT button
upwards.
For charging, use the BC-1WD for the NP-1B.
Note
Make sure you disconnect the cables connected to the
connectors (AC IN, DC 12 V IN) at the rear of the
monitor. Otherwise, the monitor cannot operate on the
battery pack(s).
SONY mark downwards
3
AC plug
holder B
Slide AC plug holder B over the cord until is locks.