9.4 Modelling light („ML")
The modelling light is a high-frequency stroboscopic flash. It creates the impres-
sion of a semi-permanent light for a duration of about 3 seconds. The modelling
light enables the user to assess light distribution and the formation of shadows
before taking pictures. The modelling light is triggered with the manual firing
button
.
Setting procedure
ML
OFF
ML
On
On
ML
After about five seconds the display stops flashing and the setting is saved
automatically.
After activation of the modelling light function „ML" appears in the display.
90
• Press the button combination „Select"
until „ML" flashes in the display.
• Apply the setting desired with the
buttons + and –.
– When „ML ON" is displayed,
the modelling light is activated.
– When „ML OFF" is displayed,
the modelling light is deactivated.
The setting takes effect immediately.
9.5 Extended Zoom Mode („Ex")
In extended zoom mode the zoom position of the main reflector
one level below the focal length of the camera lens. The resulting expanded and
broader light coverage provides additional dispersed light (reflections) inside
rooms so that a softer flash illumination is possible.
Example:
The focal length of the camera lens is 50 mm. The extended zoom mode sets a
35 mm reflector position on the flash unit. However, 50 mm continues to be
shown on the display.
Setting procedure
• repeatedly press button combination
„Select" until „Zoom" appears in the
display and „Ex" flashes.
• The required settings can be applied using
the + and – buttons.
– When „Ex On" is displayed, the
extended zoom mode is activated.
– When „Ex OFF" is displayed, the
extended zoom mode is deactivated.
The setting takes effect immediately.
After about five seconds the display stops flashing and the setting is saved
automatically.
After activation of the extended zoom mode „Ex" appears in the display.
is reduced to
Ex
OFF
Ex
On
On
Ex