Safety Guidelines; General Safety Information - Campbell Hausfeld TL146200AJ Manual Del Operador

Safety Guidelines

Observe the following symbols.
Unpacking
After unpacking the unit, inspect carefully
for any damage that may have occurred
during transit. Make sure to tighten
fittings, bolts, etc., before putting unit
into service.
ReAD & Follow All InStRuctIonS
SAve theSe InStRuctIonS
Do not DIScARD
General Safety
Information
California ProPosition 65
some dust created by power
sanding, sawing, grinding,
drilling and other constructive
activities, contains chemicals known in
the state of California to cause cancer,
birth defects or other reproductive harm.
some examples of these chemicals are:
• Lead from lead-based paints
• Crystalline silica from bricks and
cement or other masonry products
• Arsenic and chromium from
chemically treated lumber
Your risk from these exposures varies,
depending on how often you do this
type of work. To reduce your exposure
to these materials work in a well
ventilated area with approved personal
Danger indicates an imminently hazardous situation which, if
not avoided, WILL result in death or serious injury.
Warning indicates a potentially hazardous situation which, if not
avoided, COULD result in death or serious injury.
Caution indicates a potentially hazardous situation which, if not
avoided, MAY result in minor or moderate injury.
Notice indicates important information, that if not followed, may
cause damage to equipment.
www.campbellhausfeld.com
Tl146200AJ and Tl146299AJ
safety equipment, including respiratory
protection.
InstructIons PertaInIng to a
rIsk of fIre, electrIc shock,
or Injury to Persons
Use only a pressure regulated
compressed air source to limit
the air pressure supplied to the tool. The
regulated pressure must not exceed 90
psI. If the regulator fails, the pressure
delivered to the tool must not exceed
200 psI. The tool could explode which
will cause death or serious personal
injury.
• Do not operate the tool in
explosive atmospheres,
such as in the presence of
flammable liquids, gases,
or dust.
should always be followed, including the
following:
• Keep bystanders, children, and
visitors away while operating the
tool. Distractions are able to result in
the loss of control of the tool.
90 PSI
Max.
When using tools,
basic precautions
3