Connections - Sony LMD-1041 Manual De Instrucciones

Connections

Before you get started
• First make sure that the power of each piece of equipment
is turned off.
• Use connecting cables suitable for the equipment to be
connected.
• Insert the cable connectors fully into the jacks. A loose
connection may cause hum and other noise.
• To disconnect the cable, pull out by grasping the plug.
Never pull the cable itself.
• Read the instruction manual of the equipment to be
connected.
• Use the Sony specific cable (not supplied) to connect the
external control jacks.
Example of the equipment to be connected
Personal computer,
institutional video
camera/VTR, etc.
to analog RGB
output or
component signal
(YUV) output
to control to Y/C IN of
jack of other other
equipment monitor
8
VTR, laser disc player,
video game, etc.
to audio
output
Power cord
(supplied)
to a wall outlet
to VIDEO IN of
other monitor
• Use the following Sony cable (not supplied) to connect the
LINE C connector.
Computer Cable
1)
Macintosh SMF-401 and Macintosh adaptor (not
supplied)
2)
VGA SMF-401
3)
PC-98 SMF-401 and PC-98 series adaptor (not
supplied)
1) Macintosh is a registered trademark of Apple Computer
Inc.
2) VGA is a registered trademark of IBM.
3) PC-98 is a registered trademark of NEC Corporation.
Signal
YUV
Video-RGB
Institutional VTR, laser
disc player, etc.
to S video
output
YC-5V cable,
etc.
RK-G129 cable, etc.
RK-G67 cable, etc.
Cable
SMF-400
SMF-400
to control S
output of
other monitor
to control S
input of other
monitor