Installation; Attaching The Stand - Sony LMD-1041 Manual De Instrucciones

Installation

You can attach the stand to the unit and place on a table, or
hang the unit on the wall.

Attaching the stand

1 Align and insert the connecting plate of the
stand to the hanging plate of the monitor.
ill028
2 Loosely install the supplied screw.
3 Adjust the height of the monitor, and tighten the
screws.
Hanging on the wall
Caution
• Make sure that the wall is strong enough to hold 2 kg (4
lb 7 oz) weight.
• Use the 4 mm (3/16 inches) screw (not supplied).
Hanging on the wall
1 Remove the screws and remove the hanging plate
from the monitor.
2 Secure the hanging plate to the wall using the 4 mm
(3/16 inches) screws (not supplied).
Make sure that you attach the hanging plate to the cross
beam of the wall.
3 Hang the supplied plate to the rear of the monitor.
This plate is to prevent the monitor from falling.
4 Hang the monitor onto the hanging plate.
5 Secure the plate you hanged in step 3 with the same
screw as in step 2.
Screw (to prevent the
monitor from falling)
Wall
J
EN
D
F
ES
I
9