ECOVACS Deebot M8 Manual De Instrucciones página 11

Power ON
4
Press and hold the
3 seconds. DM85 is powered ON when the
button illuminates.
5
Charge DM85
Remove the Smart Clean Reservoir before
charging DM85.
Place DM85 on the Charging Dock making
sure the Charging Contacts on DM85 and the
Charging Dock Pins make a connection.
Charge DM85 for at least 12 hours before the
first use.
button blinks when DM85 is charging and stays on when DM85 is fully charged.
*
Remove the Smart Clean Reservoir before charging DM85.
*
Remove DM85's battery if the robot will not be used for a long time. In case of battery leakage,
*
please remove the battery and wipe the battery slot clean while wearing protective gloves.
If DM85's battery is fully discharged or not used for a long time, its capacity may decrease and
*
need to be reactivated.
To reactivate the battery: Place the robot on the Charging Dock by hand, remove after charging
*
for 3 minutes; repeat 3 times, then charge normally for 3-5 hours.
DM85 uses a long life battery and does not require frequent replacement. To replace the battery,
*
contact Customer Service or follow the below instructions:
a. Unscrew the Battery Pack Screws, then remove the Battery Pack.
b. Insert new Battery Pack, re-insert and tighten the screws.
6
Attach a Cleaning Cloth
To use DM85's Optional Advanced Mopping System, attach a selected Cleaning Cloth before use.
When using the mopping feature, fold area rug edges under themselves so DM85 avoids the rug.
*
Please see section 3.5 Optional Advanced Mopping System for complete instructions.
*
3. Operating and Programming
button on the robot for
3 3
ON
9
EN