Drain Hose Connection - Becken BWM3215 Manual De Instrucciones

• In order to prevent leakage at the inlet connections, a washer is provided in the hose pack (or
2 washers for models with two inlets). This/these washer(s) are to be fitted to the ends of the
inlet hose(s) that are connected to the water supply faucet.
• The new ¾˝ inlet hoses must be connected to a threaded faucet.
Connect the white right-angled end of the inlet hose to the white filtered inlet valve at the back of
the machine and the red right-angled end to the red filtered inlet (on machines with two inlets).
Tighten the plastic parts of the connections by hand. If in doubt, ask a qualified plumber to connect
the machine.
• Your machine will be at its best if connected to a 0.1-1 Mpa water supply. (0.1 Mpa pressure
means water flowing at more than 8 liters per minute at the faucet.)
• Make sure the connections do not leak and turn off the water supply when the connections
are complete.
• Make sure the inlet hoses are neither bent, nor broken, crushed or distorted.
• If your machine has two inlets, the temperature of the hot water supply should not be higher than 70°C (158°F).
Note:
Use only the new inlet hoses that were delivered with the machine to connect to the water supply. Never use old, used
or damaged inlet hoses.

2.2.1.4. Drain Hose Connection

• The drain hose can be directly connected to a wastewater drainage outlet
or to an external connection on the sink trap.
• Never attempt to lengthen the drain hose using joints.
• Do not place the drain hose for your washing machine in a container,
bucket or sink.
• Check that the drain hose is not bent, burst, crushed or stretched.
Remember:
• The drain hose should be installed at a minimum height of 60 cm and a maximum of 100 cm from the floor.
10