Leveling The Washing Machine; Electricity Supply; Connecting The Inlet Hose - Becken BWM3215 Manual De Instrucciones

2.2.1.1. Leveling the Washing Machine

• Do not install washing machines on a carpet or on surfaces that prevent the base from being ventilated.
• To guarantee that the washing machine runs silently and does not vibrate, it should be installed on a solid, non-
slip surface.
• The machine is fitted with adjustable leveling feet.
• Loosen the plastic counter-nut.
• Turn the feet to raise or lower each corner until the machine is level.
• When the machine is level, re-tighten the plastic counter-nut.
• Never use cardboard, wood or similar materials underneath the feet to level the machine.
• Be careful not to change the position of the feet when cleaning the floor around the machine.

2.2.1.2. Electricity Supply

• Your washing machine is set to use a 220-240 V, 50 Hz power supply.
• The power supply cord on your machine is fitted with an earthed plug. The machine should
always be plugged into a 10 amp earthed wall socket.
• The fuse must be 10 amps rated. The fuse on the mains power supply circuit must also be
10 amps rated. If you do not have a compatible circuit in your home you should contact a
qualified electrician to have one installed.
• We decline any liability for damage resulting from the use of an un-earthed power outlet.
NOTE:
Running your machine at a lower voltage will reduce its service life and deteriorate its performance.

2.2.1.3. Connecting the Inlet Hose

• Your machine may have a single inlet (cold water) or twin water inlets (hot and cold), depending
on its specifications. The hose with the white top should be connected to the cold water inlet
and the hose with the red top to the hot water inlet (for machines with two water inlets).
Washing Machine | Lavadora | Máquina de Lavar Roupa
EN
9