Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARATION
1.
Sit the motor unit on a stable, level surface.
Align the d on the bottom of the jug with the U on the motor unit.
2.
Lower the jug on to the motor unit, then turn the jug to align the d with the L.
3.
4.
Turn the lid anti-clockwise to unlock it then lift it off the jug.
5.
Put the ingredients into the jug.
6.
Don't fill past the 1500ml mark. If you do, the contents may force the lid off when you start
the motor.
7.
Place the lid onto the jug with the tab as shown in figure A.
8.
Twist the lid clockwise to lock it (fig. B)
9.
Push the cap into the hole in the lid.
10. Don't run the appliance without fitting the cap.
11. Check that the speed control is set to 0.
12. Put the plug into the power socket.
SPEED CONTROL
1.
Turn the speed control to the speed you want (1 = low, 2 = high).
2.
Turn the speed control back to 0 to turn the motor off.
3.
Generally, large quantities, thick mixes, and a high ratio of solids to liquids suggest longer
timings and slower speeds.
4.
Smaller quantities, thinner mixes, and more liquids than solids suggest shorter timings and
higher speeds.
5.
Don't run the motor for more than 1 minute, or it may overheat. After 1 minute, switch off
for at least 2 minutes, to let the motor cool.
PULSE
Turning the speed control anti-clockwise to Y will give you a short burst at high speed. In this
direction, the knob is spring-loaded. When you let go, it'll return to 0.
ADDING INGREDIENTS
To add ingredients while the blender is working, remove the cap, pour the new ingredients
through the hole, then replace the cap.
Check that the added ingredients don't increase the volume in the jug past the 1500ml mark.
CARE AND MAINTENANCE
1.
Switch the appliance off (0) and unplug it.
2.
Wipe the outside of the motor unit with a clean damp cloth.
3.
Wash the removable parts in warm soapy water, rinse well, drain, and air dry.
4.
Don't put any part of the appliance in a dishwasher.
BLADE UNIT
You may remove the blade unit for cleaning. This is best done with the jug turned upside down.
1.
Grip the jug handle with one hand.
2.
Grip the bottom of the blade unit with the other hand.
3.
Turn the blade unit clockwise till it comes loose from the jug base.
4.
Carefully, pull it up and out of the bottom of the jug.
5.
Lift the seal away from the blade unit.
6.
Wash the seal and blade unit in warm soapy water, rinse, and air dry.
7.
Take great care with the blades – don't handle them directly, use a nylon washing-up brush.
8.
Replace the seal round the blade unit.
9.
Replace the blade unit in the jug base.
10. Turn the blade unit anti-clockwise to tighten it.
W
ENVIRONMENTAL PROTECTION
To avoid environmental and health problems due to hazardous substances in electrical and
electronic goods, appliances marked with this symbol mustn't be disposed of with unsorted
municipal waste, but recovered, reused, or recycled.
4
Publicidad
Tabla de contenido
