Gude SG 130 A Traducción Del Manual Original página 30

ENGLISH
26
Guarantee
Warranty period of 12 months applies to commercial
use and 24 months applies to private use and com-
mences on the day of purchase of the device.
The guarantee solely covers inadequacies caused
by material defect or manufacturing defect. Original
payment voucher with the sales date needs to be
submitted for any claim in the guarantee period.
The guarantee does not cover any unauthorised
use such as appliance overloading, use of violence,
damage as a result of any unauthorised interference
or caused by foreign items. Failing to follow the ope-
rating and assembly instructions and common wear
are also not included in the guarantee.
Service
Do you have any technical questions? Any claim? Do
you need any spare parts or operating instructions?
We will quickly help you and without needles bureau-
cracy at our web pages at www.guede.com in the
Servicing part. Please help us be able to help you. In
order to identify your device in case of claim we need
the serial No., product No. and year of production. All
this data can be found on the type label.
Failure removal
Issue
Wire not feeding despite wire feed
pulley turning.
Interrupted or disruptive wire
supply
Electric arc turned off
Porous welded joint
Welder suddenly stops working
after longer operation
Seriennummer
Artikelnummer
Baujahr
Important information for the
customer
Please note that returns within or outside the warran-
ty period should always be in the original packaging.
This measure effectively avoids unnecessary transport
damage and any associated disputed ruling. Your
equipment is optimally protected only in the original
box, and keeping it in that box will ensure smooth
processing.
Causes
Dirty current nozzle
Coil carrier clutch set too tight.
Damaged hose bundle
Too low clamping pressure of the
wire feed pulley
Damaged current nozzle
Burnt current nozzle
Dirty driving gear nozzle
Cut on worn driving gear
Poor contact between earth pliers
and the respective part
Short circuit between current nozzle
and gas supply pipe
Too loose current nozzle
Wrong distance of inclination of the
hose bundle
Welder has overheated due to too
long use and the thermal protection
has activated
Removal
Clean
Loosen
Check the wire guide housing
Increase the clamping pressure
Replace
Replace
Clean
Replace
Tighten the pliers and check them
Remove paint and rust
Clean or replace contact tip and
gas jet
Current nozzle without dirt, paint and
rust remains
Tighten the current nozzle firmly
Distance between the hose bundle
and the respective part must be 5-10
mm. Inclination must not be lower
than 60 with respect to the part.
Let the welder cool down