Storage After Use; Disposal Procedure - Hitachi Koki CM14E Manual Del Operador

Do not store in enclosure where fuel fumes
may accumlate or reach an open fl ame or
spark.
NOTE
For future reference, you should keep this
operator's manual.
GB
Mark
>PA6-GF<
>PP-GF<
>PE-HD<
GUARANTEE
We guarantee Hitachi Power Tools in
accordance with statutory/country specifi c
regulation. This guarantee does not cover
defects or damage due to misuse, abuse, or
normal wear and tear. In case of complaint,
please send the Power Tool, undismantled,
with the GUARANTEE CERTIFICATE found at
the end of this Handling instruction, to a Hitachi
Authorized Service Center.

Storage after Use

WARNING

Disposal Procedure

Material
Nylon 6 - Glass fi ber
Polypropylene - Glass fi ber
Polyethylene
Inspect and adjust every part of the cutter.
- Completely clean every part and repair if
necessary.
- Apply thin coating of oil on metal parts to
prevent rust.
Remove cutting wheel.
Drain fuel tank, pull starter slowly a few times to
drain fuel from carburettor.
Pour a small amount of clean motor oil into
spark plug hole, pull starter and crank the
engine until piston reaches: Top Dead Center.
Store in a dry area, free from dust.
Dispose of waste oil in accordance with local
regulations.
Major plastic parts making up the product have
codes showing their materials.
The codes refer to the following materials;
dispose of those plastic parts in accordance with
local regulations.
24