Operation; Manual Bed Operation - Sunrise Medical GUARDIAN IC-5307 Manual De Instrucciones

12
POSSIBLE INJURY or damage. Electric beds are for use on a nominal 120 volt cir-
cuit and have a grounding plug that looks like the plug illustrated in Figure 42.
Make sure the unit is connected to an outlet having the same configuration as
the plug. No adapter should be used with the this plug.
POSSIBLE INJURY. Before adjusting bed, check that nothing is under or near the
bed. Keep children and pets away from the bed to prevent injury.
The back section can be adjusted to any angle from flat for sleeping to full sitting for eat-
ing, reading or watching TV.
The knee section can be adjusted to any angle from flat to its highest possible position.
Changing this angle from time to time changes blood circulation and pressure points in
lower body parts and improves user comfort.
The entire bed can be adjusted from lowest position, for safe entry and exit, to its highest
position, where it is easier to care for the patient. Bedding changes, clothing changes,
patient bathing and feeding are all much easier with the bed higher.
POSSIBLE INJURY. Keep bed in lowest position except for providing care (bathing,
clothing changes, etc.). Entering or exiting a raised bed could result in falls or
injury.
RISK OF SERIOUS INJURY OR DEATH. Do not use liquids in or around electric bed.
In case of a spill, unplug bed immediately. Clean up the spill and allow the area
to dry completely before resuming use of the electric bed. Failure to do so could
result in shock or electrocution.
POSSIBLE DAMAGE OR INJURY. When operating the bed, keep all moving parts
free of obstacles such as blankets, sheets, heating blankets/pads, wiring, tubing
and other items with electric cords which may get tangled around the bed, side
rails or legs.

MANUAL BED OPERATION

1. Manually turn cranks for each bed function from the beginning of the adjustment to the
end and back again, as instructed below. The crank and the function should operate
freely and smoothly.
2. If any problems arise, check all mechanical hookups.
3. The Set Height bed (IC-5107) has head and foot functions, but the height of the bed
is not adjustable.
4. To raise entire height of Single Crank Hi/Lo bed (IC-5307), turn crank 2 clockwise. To
lower height, turn crank 2 counterclockwise (Figure 43).
5. To raise height of Two Crank Hi/Lo bed ends individually (IC-5207), insert crank 4
(not shown) into head and foot ends and turn clockwise. To lower, turn crank 4 coun-
terclockwise.
6. To raise head section of all manual beds, turn crank 1 clockwise. To lower, turn crank
1 counterclockwise.
7. To raise foot section of all manual beds, turn crank 3 clockwise. To lower, turn crank
3 counterclockwise.
E n g l i s h

OPERATION

WARNING
WARNING
WARNING
WARNING
WARNING
O p e r a t i o n
Grounded
Outlet
Grounding Pin
Crank 1
40
41
42
43
Crank 3
Crank 2