Installation And Assembly - Bossini Z00063000073005 Instrucciones De Montaje

INSTALLATION AND ASSEMBLY

1. Create a space in the wall for the single lever mixer and its plastic protective casings. (Fig.1)
2. Lodge the cold water supply pipes to the lower right hand side, while the hot water pipes to
the left. On both the top and bottom areas, lodge the sanitary supply pipes. (Fig.2)
3. To prevent impurities or debris from entering the mixer and causing operating
problems, flush out the system before connecting the supply pipers. The
installation of a special inflow filter is recommended.
4. Place the single lever mixer complete with plastic protective casings, paying attention that the
surface level of the tiles-finished wall is within 44.3 and 69.3 mm. (Fig.3)
5. Complete the connections as shown in Figure 4.
6. Check the plant and verify the absence of any leak
7. Clad the walls, see Fig. 5.
8. Remove the plastic protections (Fig. 6).
9. Remove any filth/impurities on the surface of the single lever mixer and/or tiles (Fig.7)
10. For the version with round exposed parts, start from point 11; for the version with square
exposed parts, start from point 13.
11. Remove the film from the sponge in the backside of the cover plate (6). Insert the plate on the
bush and on the diverter sticking out of the concealed part of the mixer and push the plate
against the wall (fig. 8)
12. Insert the mixing/on-off handle and (7) keeping the hole pointed upwards, as per figure 8.
Fasten the handle by the specific threaded pin (8) and insert the cap (9). Then continue from
point 16.
13. Remove the film from the sponge in the backside of the cover plate (6). Insert the plate on the
bush and on the diverter sticking out of the concealed part of the mixer and push the plate
against the wall (fig. 9)
14. Insert the spring (11) on the pivot of the diverter (10) and on the mixing/on-off handle, keeping
the hole pointed upwards, as per figure 9. Fasten the handle by the specific threaded pin (8) and
insert the cap (9).
15. Position the knob (12) on the pivot of the diverter and screw the knob while pressing (fig. 10)
16. Clean the mounted components with care (Fig. 11).
13