Hitachi Koki CJ 18DGL Instrucciones De Seguridad Y Manual De Instrucciones página 15

When cutting stainless steel plates, adjust the unit as
described below:
(1) Adjust the speed
Blade Thickness of material
1/16" – 5/32"
No. 97
(1.5 – 2.5 mm)
NOTE
The higher the speed is, the quicker the material is
cut. But the service life of the blade will be reduced in
this case. When the speed is too low, cutting will take
longer, although the service life will be prolonged.
Make adjustments as desired.
(2) Set the orbital position to "0"
NOTE
When cutting use cutting fl uid (oil base cutting fl uid)
to prolong the blade's service life.
Speed
Middle speed
English
15