Basic Safety Instructions - Ega Master 79612 Manual De Instrucciones

Insert tool
Slide the socket over the square drive (see fig. 6).
Pay attention that the socket is firmly seated.
Only use sockets with suitable shank (see "Technical Specification").
Remove the socket
Pull the socket from the square.
Sockets being stuck can be loosened by slight beats with a rubber hammer.
Change the sockets
When inserting a socket, pay attention that it is properly seated on the square drive 6. If the socket
is not firmly fixed to the square drive, it can unscrew.
Read operation instructions/safety instructions!
Before working on or with the tool, read the safety instructions and follow the
instructions during operation.
Do not modify machine or machine tools and accessories after receipt. Permission from the
manufacturer must be obtained before any modifications or alterations are done in compliance with
all safety instructions. Use the machine only for its intended use. Observe the technical data of the
equipment and the ambient temperatures. Pay attention to labels, restrictions of use and special
instruction notes on the machine tools and the machine itself. Regularly check that the type plate and
symbols on the machine are legible. If necessary, contact the manufacturer to replace them. Only
operators with technical knowledge, trained by authorized responsible technical personnel, may install,
adjust, operate, transport and store the machine.
Generally, the employer is responsible for the faultless condition/operation of the machine and the
adherence to the safety regulations. The machine is designed and manufactured according to the
technical safety regulations. However, using it, there is still a risk of accidents to the operator or third
parties or damage to the machine or other objects. All current regulations and specifications, which
apply to the site of operation in regards to accident prevention, installation of electrical and mechanical
systems as well as radio interference must be considered.
Fig.6

BASIC SAFETY INSTRUCTIONS

EMPLOYER'S OBLIGATIONS
27