Basic Safety Instructions - Ega Master 79631 Manual De Instrucciones

Insert tool
Slide the socket over the square drive (see fig. 6).
Pay attention that the socket is firmly seated.
Only use sockets with suitable shank (see "Technical Specification").
Remove the socket
Pull the socket from the square.
Sockets being stuck can be loosened by slight beats with a rubber hammer.
Change the sockets
When inserting a socket, pay attention that it is properly seated on the square drive 7. If the
socket is not firmly fixed to the square drive, it can unscrew.
the instructions during operation.
Do not modify machine or machine tools and accessories after receipt. Permission from the
manufacturer must be obtained before any modifications or alterations are done in compliance
with all safety instructions. Use the machine only for its intended use. Observe the technical
data of the equipment and the ambient temperatures. Pay attention to labels, restrictions of use
and special instruction notes on the machine tools and the machine itself. Regularly check that
the type plate and symbols on the machine are legible. If necessary, contact the manufacturer
to replace them. Only operators with technical knowledge, trained by authorized responsible
technical personnel, may install, adjust, operate, transport and store the machine.
32

BASIC SAFETY INSTRUCTIONS

Read operation instructions/safety instructions!
Before working on or with the tool, read the safety instructions and follow
Fig.6