Stiga CS 80 Li Manual De Instrucciones página 33

2. When the safety button
is pressed, the green light
does not come on and the
block release button flashes
3. The motor shuts down
whilst working
4. The motor stops while
working and the safety
button flashes
5. With the throttle lock button
and throttle control lever
on, the chain does not turn
6. The chain heats and
emits smoke on the
end part of the bar.
7. The motor runs
irregularly and lacks
power when revved
8. Excessive noise and/or
vibration is experienced
whilst working
9. Battery power reserve is low
Low battery
Battery is not inserted correctly
Low battery
Excessive chain tensioning
Bar and chain problems
Machine damaged.
Excessive chain tensioning
Lubricant oil tank empty.
Bar and chain problems
Loose or damaged parts
Severe working conditions
requiring greater
current absorption
Battery is insufficient for
operating requirements
Decrease in battery capacity
EN - 16
Check the battery
status and recharge if
necessary (par. 7.2.2).
Make sure that the battery is
inserted correctly (par. 7.2.3).
Check the battery
status and recharge if
necessary (par. 7.2.2).
Re-tension the chain
(par. 6.1.3).
Check that the chain runs
freely and the bar guides are
not deformed (par. 8.3, 8,4).
Do not use the machine.
Immediately turn off
the machine remove
the battery and
Contact a Licensed
Service Centre.
Re-tension the chain
(par. 6.1.3).
Fill the lubricant oil
tank (par. 7.3).
Check that the chain runs
freely and the bar guides
are not deformed.
Turn off the machine
remove the battery and:
– inspect for damage;
– check for and tighten
any loose parts;
– have any damaged parts
replaced or repaired with
parts having equivalent
specifications.
Optimise operations
(par. 7.2.1)
Use a second battery or an
extended battery (par. 7.2.1)
Purchase a new battery