Location Requirements - Maytag KDFE104DBL5 Manual De Instrucciones

For Direct Wire
Cabinet Grommet
For 1 / " (38 mm) hole in
1
2
cabinet. (Whirlpool
Part Number 302797)
NOTE: Required for metal
cabinets
Call us at our toll-free number, visit our website listed in the User
Guide for part numbers above, or see local electrical supply
retailer for equivalent.
6
For Power Cord
Power Cord Kit
Kit typically includes
power cord, metallic strain
relief, grommet, and twist-on
wire connectors. (Whirlpool
Part Number 4317824)

LOCATION REQUIREMENTS

Dishwasher must be fully enclosed (top, sides, back, and floor)
upon installation. A side panel kit is available from your dealer
for installing your dishwasher at the end of your cabinetry.
An optional moisture barrier accessory is also available for
installing underneath a wooden countertop. See the "Tools
and Parts" section at the front of the guide for part details
and orders.
Check location where dishwasher will be installed. The location
must provide:
Convenient access for loading and unloading dishes. Corner
■
locations require a 2" (51 mm) minimum clearance between
the side of the dishwasher door and the wall or cabinet.
Easy access to water, electricity, and drain:
■
Grounded electrical supply is required.
■
This dishwasher has a water heating feature and also
■
requires a connection to a hot water supply line.
Make sure pipes, wires and drain hose are within the
■
shaded area shown in the "Product and Cabinet Opening
Dimensions" section.
Do not run drain lines, water lines, or electrical wiring where
■
they can interfere with or contact dishwasher motor or legs.
Shelter dishwasher and water lines leading to dishwasher
■
against freezing. Damage from freezing is not covered by
the warranty.
NOTE: If dishwasher will be left unused for a period of time
or in a location where it may be subject to freezing, have it
winterized by authorized service personnel.
If installed in new construction, flush the water supply line
■
of debris before connecting it to the fill valve. If it is not
flushed, debris from the water supply could plug the fill
valve screen.
A square opening for proper operation and appearance
■
The cabinet front to be perpendicular to floor
■
A level floor
■
Helpful Hint: If floor at front of opening is not level with floor
at rear of opening, shims may be used to level dishwasher.
NOTE: To avoid shifting during dishwasher operation, shims
must be securely attached to the floor.
The location where the dishwasher will be installed must
■
provide clearance between motor and flooring. Motor should
not touch the floor.
Do not install dishwasher over carpeted flooring.
■