Omnitronic Kill-Mixer FX-524 Manual Del Usuario página 17

• Additionally, the FX-524 features two more ¼" MIC 2 and MIC 3 jack-sockets on the rearpanel. You can
adjust the microphone volume using the CH-2 and CH-3 fader. Make sure that the PHONO/LINE/MIC-switch
is set to MIC.
Occupation unbalanced mono-1/4" jack-plug:
• You can connect up to 3 record players using the PHONO 1 sockets, PHONO 2 sockets and PHONO 3
sockets on the rearpanel. You can only control the record player signal after you switched the
PHONO/LINE/MIC switches to PHONO. The signal is then controlled via the CH-1, CH-2 and CH-3 faders.
• The short-circuit plug can only be plugged in unused Phono input-sockets in order to protect the input. This
plug must never be plugged into output-sockets or Line input-sockets.
• Connect your CD-player, DAT-recorder, cassette deck, tuner, tape recorder or all other line signals to the
LINE input-sockets on the rearpanel. You can only control the line signals after you switched the
PHONO/LINE/MIC switches to line. The signal is then controlled via the respective faders.
• Switch the device on. After switching on the amplifier, wait 8 to 10 seconds until you turn the volume-
controls in order to avoid speaker-damage.
• Under all circumstances avoid amplifier clipping. Distorted signals are the major cause of speaker-damage.
17