Problem Chart; Cleaning And Maintenance; Replacing The Fuse - Omnitronic Kill-Mixer FX-524 Manual Del Usuario

PROBLEM CHART

PROBLEM:
No power.
No sound.
Noise.
No crossfader.

CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no servicable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device will be damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Please note: This fuse is being used for both 115 V and 230 V.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Unscrew the fuseholder on the rearpanel with a fitting screwdriver from the housing (anti-
clockwise).
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing and fix it.
CAUSE:
• The power-cord is not connected.
• The PHONO/LINE/MIC-switch of the
respective channel is in the wrong
position.
• The power-cord of the respective
device is not connected properly or
not connected at all.
• The connection-socket or the plug is
dirty.
• The input-signal is too strong.
• The crossfader was not assigned
properly.
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
• Check the power-cord and any
extension-cables.
• Put the PHONO/LINE/MIC-switch
into the correct position.
• Check the power-cord and if the
plugs are tightly connected with the
sockets.
• Clean the socket and/or the plug.
• Reduce the input-signal via the Gain-
control.
• Assign the desired channel to the
crossfader via the Crossfader Assign-
button.
21
REMEDY: