Replacing The Crossfader; Technical Specifications - Omnitronic Kill-Mixer FX-524 Manual Del Usuario

Replacing the Crossfader

Instructions for replacing the crossfader:
• Remove the fader knob.
• Remove the two outer screws on the fader-panel.
• Take the fader out and unplug the connection-cable.
• Connect the new fader and fix it in the device.
The fader-panel of the replacement-crossfader cannot be used for the Design-version. In order to exchange
the fader-panels, additionally unscrew the 2 inner screws and exchange the two fader-panels.

TECHNICAL SPECIFICATIONS

Power supply:
Power consumption:
Inputs:
Minimum input voltage:
Microphone:
Phono:
Line:
Output voltage:
Line:
Headphones:
Outputs:
Frequency range:
Microphone:
Phono:
Line:
Distortion:
S/N-ratio:
Microphone:
Phono:
Line:
Talkover-attenuation:
Tone control:
Treble:
Middle:
Bass:
Dimensions (WxDxH):
Weight:
Replacement crossfader:
Please note: Every information is subject to change without prior notice. 02/01 ©
115/230 V AC, 50/60 Hz ~
30 W
3 phono, 3 line, 3 mic
3 mV RMS, 2.2 kOhms
3.2 mV RMS, 47 kOhms
150 mV RMS, 4.7 kOhms
7 V RMS max.
0.4 V
1 Master-Out, 1 Rec-Out, 1 Booth-Out via RCA
20 - 20,000 Hz, ± 3 dB
20 - 20,000 Hz, ± 3 dB
10 - 50,000 Hz, ± 3 dB
< 0.05 %
-60 dB
-50 dB
-64 dB
-14 dB
15 KHz -60 dB to +12 dB
1 KHz -30 dB to +12 dB
50 Hz -60 dB to +18 dB
254 x 320 x 99 mm
3.5 kg
No. 10007190
22