Overview Of The Controls; Initial Operation - Clatronic DR 2812 Instrucciones De Servicio

5....-05-DR 2812
GB
• The device is equipped with a thermostat for temperature restriction, a safety
fuse and a safety lock.
• The device must not be opened during use.
• During use the device must not be tilted by more than 45° as boiling water
could be spilled together with the steam.
• Never direct the steam jet towards people, animals or electric devices (e.g. into
the oven).
• Please do not immerse the device in water or other liquids.
• When refilling, always pull the power plug from the socket.
• Do not overfill! Please do not exceed the amount of water indicated on the mea-
suring beaker.
• Store the device out of the reach of children.
• Do not touch the hot surfaces. If you would like to change the accessories, plea-
se wait until the device has cooled down.
• The device must not be used to clean electrical equipment or installations.
• Please do not add anti-liming agents, solvents, alcohol or cleaning agents as
these may damage the device or have a dangerous effect.
• Do not use the device if it is damaged.
Caution! Before you begin cleaning you should test the materials to be clea-
ned as to their suitability for cleaning with steam. Do not hold the steam
nozzle for too long and too close in one position.
1 On/off switch
2 Kettle/water tank
3 Hose with connecting head
4 Safety lock/Filling aperture
5 Steam switch on the
connecting head
6 Carrying handle
7 Connection cable
Filling up the Heating Boiler before Use!
Before the tank lock is opened the power plug must be removed
from the socket. Please make sure the device is depressurized by
pressing the steam switch.
Caution! Before unscrewing the lock (4) proceed as follows:
40
19.09.2003 11:32 Uhr
Special Safety Advice

Overview of the Controls

8
9
10 2 extension tubes
11 Jet nozzle with round
12 Floor brush nozzle
13 Window wiper
14 Non-woven cover

Initial Operation

Seite 40
Funnel
Measuring beaker
brush attachment