Switching On The Device - Clatronic DR 2812 Instrucciones De Servicio

5....-05-DR 2812
• Remove the power plug from the socket.
• Release the pressure by using the steam switch (5).
• If the device is still warm, please wait 5 minutes before removing the
seal completely. Press the seal downwards and turn.
Caution! Danger of Injury!
Please open the safety lock (4) only when no more steam comes
out of the nozzle. Shake any residual water out of the kettle (2). Then
fill the measuring beaker (9) and pour the water into the kettle. Use a
funnel (8) if necessary. Re-fasten the safety lock (4).
Attachment of the Individual Accessories
It is possible to attach the individual nozzles directly to the connecting head of the
hose (3):
• Attach one of the nozzles to the connecting head of the hose until it locks in
place.
• In order to release the nozzle again please press the button on the connecting
head of the hose.
• Keep the button pressed down and then pull the nozzle off.
or extend the nozzle attachments with one or two extension tubes (10).
• Insert one extension tube into the other until it locks in place and then insert the
connected tubes into the handle section (3).
• Then attach the floor brush nozzle (12) or the accessories.
• In order to release the extension tube, please press the button on the connec-
ting head.
Jet nozzle with round
brush attachment (11):
Floor brush nozzle (12):
Window wiper (13):
Non-woven cover (14):
• Before inserting the mains lead into the socket, check whether the voltage you
intend to use complies with that of the machine. For details see the machine
label.
• Only connect the machine to a properly installed safety socket, 230 V/50 Hz.
• Turn the on/off switch (1) on top of the device to "I".
19.09.2003 11:32 Uhr
For cleaning joints, the edges of bath tubs or areas
which are difficult to access etc.
For large surfaces, such as laminate or tiles etc.
For window cleaning, shower partitions etc.
Non-woven cover for sensitive surfaces. Please use the
cover together with the window wiper.

Switching on the Device

Seite 41
GB
41