Hella Jumbo 320 Xenon Instrucciones De Montaje página 11

Mounting specifications
according to ECE-Regulation 48,
StVZO § 50 must be complied
with!
A min. B max.
(mm) (mm)
11
D
350 1.500
Required tools
•Measuring scale •All-purpose pliers
Page 3 Mounting
To run a position light in an auxiliary
headlamp, certain mounting
dimensions must be complied with.
Should these legal mounting
specifications not be complied with, or
the use of an additional pair of position
lights not be permissible, the position
light must not be operated. For reasons
of keeping the lamp airtight, the position
light must remain within the auxiliary
C min. D min.
headlamps.
(mm) (mm)
400 600
• Pliers for crimp joint
• Open-jawed wrench or ring
spanner SW 17
Mounting is possible upright or
pendant, above or below the bumper.
The headlamps must not vibrate or
project above the engine hood and
must be installed symmetrically.
Determine mounting area on a straight
surface and mark the fastening points.
Pre-drill with 3 mm and drill to 11 mm.
Legal approval of the countries for
additional position light:
G H
F
D
H H
A S
H
H
NL
CH
H
GB
G required Hnot required
by the law by the law
• Drilling machine with
drills Ø 3, 5, 6, 11, 12 mm
• Hexagon socket screw key 3.6 mm
Seal the drilled metal parts with rust
protection.Pre-mount the holder.
Screw the headlamps to the vehicle
(if necessary, with a two-point holder).
Align the headlamps and tighten all
the screws.
H
E
H
I
H
FIN