Available Functions - Palazzetti BLE Manual De Uso Y Funciones

It is advisable to turn off the stove strictly following the above and always avoid doing so by un-
plugging it from the power supply.
4.4 Operation with external thermostat
When the stove is controlled by an external thermostat (or chronothermostat), the installer must have input
configuration 2. In this case, the stove switches off when the external thermostat is reached (open circuit).
The stove switches back on automatically when the temperature falls below the value set on the external
thermostat (closed circuit).
With the first ignition, or if the switch-off has occurred directly from the stove (key
stove must be switched on directly from the control panel.
4.5 Operation with room sensor on stove
The stove can be switched on/off manually or programmed.
The stove modulates the power according to the room temperature detected by the probe on board (i.e.
the stove attempts to maintain the desired temperature by consuming as little fuel as possible).
If the user has enabled "Eco-mode", the stove switches off, instead of modulating, when the set temperature
has been reached and switches on again when the room temperature falls below the set delta.
It is possible to set the desired room temperature in the temperature menu
5

AVAILABLE FUNCTIONS

5.1 Timer
It is possible to set, enable and assign to the various days of the week the customised programs for the
automatic switching on and/or off of the stove.
Up to six customised programs can be configured.
For each program it is possible to set: start time, switch off time and desired temperature.
Up to three programs can be assigned to each day of the week.
The days of the week are identified by numbers: Monday = "d1", Tuesday = "d2"; ...; Sunday = "d7".
5.1.1 Program settings
a) Use the arrow keys to go to the set-up menu
b) Select the password "7" with the
c) Select the submenu
d) Scroll with the and
e) The switch-on time will flash; change the value with the
f) The minutes value will flash; change the value with the
g) The value of the switch-off time will flash; change the value with the
key;
h) The minutes value will flash; change the value with the
i) The desired temperature value will flash; change the value with the
j) Press the key to confirm the data entered.
28
key and confirm with the
[2]
and confirm with the
keys the programs
and press the
key;
key;
P1...P6
; select the one to be modified with the
and keys and press the
and keys and press the
and keys and press the
), the
.
key;
key;
key;
and keys and press the
key;
and keys;
004778040 - 07/10/2020
key;