Wheel Replacement - Makita GB602 Manual De Instrucciones

2
1
In condition Fig. 10, move the balance weight so that
when the wheel is turned it will not stop at the same place
but at random. Then fasten the stop screws on the
balance weight and firmly tighten the flange nut.
GB602W only
How to attach saw blade-sharpening kit
1
2
■ Assembly and attach saw blade sharpening kit as in
Fig. 12.
Before using, make sure it is securely fastened.
1
5 6
4
Place the saw blade between holder A and holder B.
Then secure the assembly on the screw with the wing nut
A.
1
The angle adjustment can be made by loosening the hex
bolts on the bevel scale plate. After adjusting the angle,
tighten the hex bolts securely.
8
1. Nut
2. Balance weight
3. Stopper screw
3
Fig. 11
1. Saw blade
sharpening kit
2. Bolt
Fig. 12
1. Grinding wheel
2. Screw
2
3. Wing nut A
3
4. Tool rest holder
5. Wing nut B
6. Stopper
7. Holder B
7
8
8. Tool rest
Fig. 13
1. Hex bolt
Fig. 14
2
1
4
5
Loosen the wing nut B and slide the holder B so that the
"gullet" or slot between the saw blade Teeth
just comes in contact with the edge of the Wheel. Slide
the stopper so that it comes in contact with the holder B
and tighten the wing nut B securely.
WARNING:
Always disconnect the bench grinder from the power
source before performing any assembly or adjustment.
Failure to do so could result in accidental starting resulting
in possible serious personal injury.

WHEEL REPLACEMENT

See Fig.16.
If you must replace a grinding wheel, be sure to obtain
one with a safe rated speed at least as high as the "no
load speed" RPM marked on the data plate of the grinder
and which is marked to comply with SAA.
To replace the grinding wheel, remove the wheel cover by
loosening the screws with holding the nut wrench.
Loosen the wheel nut in a clockwise direction for the left
side and a counterclockwise direction for the right side
using. Remove the outer flange and grinding wheel. To
install a new grinding wheel, reverse the above
procedure.
Be sure the grinding wheel and outer flange are properly
seated on the spindle shaft.
1
1
1. Saw blade
3
2. Screw
3. Grinding wheel
4. Wing nut A
5. Holder A
Fig. 15
1. Wrench
2. Wheel cover
2
Fig. 16
1. Wrench 8
2. Wrench 10
2
Fig. 17