SHERCO CityCorp 125 Manual De Propietario página 6

C O N T R O L S
D a s h b o a r d
4 5 6 7
3 2 1
1. Main electrical switch (two active positions)
a. Engine can be started
b. Engine is off and cannot be started
2. High beam indicator light.
3. Neutral warning light: illuminated (engine must be running) when the gearbox is in
the neutral position.
4. Turn signal indicator light: flashes when the turn signals flash.
5. Headlight indicator light: illuminated when the headlight is in the low beam position.
6. Speedometer.
7. Odometer in kilometers.
L e f t H a n d l e b a r C o n t r o l S w i t c h
1 4
2 3
1. Lights switcher
2. Turn signal switch.
3. Horn button.
4. Electric start button.
8
M a i n s w i t c h e r
B A
G e a r s h i f t l e v e r
1
5
4
3
2
N
1
1. The gear shift lever which is located
on the left side of the engine is
used to select the 5 gears in the
transmission.
F u e l
1. The fuel petcock has three positions:
OFF: When the lever is in this position, fuel will not flow. Always return the lever to
this position when the engine is not running.
ON: With the lever in this position, fuel flows to the carburetor. Normal riding is
done with the lever in this position.
RES: This is the reserve position. If you run out of fuel while riding, move the lever
to this position.
I N I T I A L
The break in period if 500 km. During this period it is mandatory that you follow
the procedures described below.
If these procedures are not followed the life of your motorcycle may be drastically
reduced.
Do not accelerate or race the engine immediately after starting. Let the engine
idle for a few minutes in order for it to warm up.
Do not run at full load during the break in period.
In order to validate the manufacturers warranty, you must return your Sherco
motorcycle to your authorized Sherco dealer at the end of the 500 km break in
period.
p e t c o c k
1
O P E R A T I O N
9