SHERCO CityCorp 125 Manual De Propietario página 9

A i r f i l t e r
1
1. Remove the seat.
2. Remove the air filter cover (1).
3. Remove the air filter (2).
4. Clean the element with soap and
water, squeeze the element to
remove any excess water. Allow to
dry completely.
5. Impregnate the element with spe
cialair filter oil.
ref. 530
6. Reinstall the air filter element.
7. Reinstall the cover, making sure
that it makes good contact with
the airbox.
8 Reinstall the seat.
B r a k e
Min
level
IIf the brake fluid level is below the minimum level,
add DOT 4 brake fluid to the maximum mark.
Always use the same type of brake fluid.
14
B r a k e p a d w e a r
2
Pad thickness
Remove both pads, if one or both
pads measure less than 1mm
they should be replaced.
f l u i d l e v e l
Max
level
Min
level
F r o n t b r a k e a d j u s t m e n t
1. Loosen the lock nut (1).
2. Turn the adjuster (2) until you
obtain a 10 mm (approx.) clearan
ce between the brake lever and the
handlebar grip.
3. Tighten the lock nut (1).
R e a r b r a c k a d j u s t m e n t
1
2
The top of the brake pedal should be
approx. 15 mm belos the top of the foot
peg.
1. Loosen the lock nut (2).
2. Turn the adjuster (1) until you obtain
the 15 mm dimension. Apply pressure
to the brake pedal when you have the
correct dimension.
3. Tighten the lock nut (2).
1 2
10 mm
3
The rear brake pedal should have a
clearance of approx. 3 mm with
the stop screw.
1. 1. Loosen the lock nut (3).
2. Turn the adjuster until you obtain
the 3 mm dimension.
3. Tighten the lock nut (3).
15