Cata 07042311 m Instrucciones De Uso página 37

or hard utensils, as they can damage the surface finishes.
Do not use high pressure cleaners or steam appliances for
cleaning the oven.
Normally, wiping with a damp soft cloth and warm deter-
gent is enough, but for stubborn stains the following is re-
commended:
VITRIFIED ENAMELLED PARTS
Only use a recommended cleaner for this type of material –
avoid chloride-based products such as bleach.
OVEN CLEANING SYSTEM EQUIPPED WITH THE AQUAS-
MART SYSTEM
1 Take out the internal components: tray, screen, side screens.
2 Pour 200 ml of soapy water on the bottom of the oven
3. Turn on and set the oven at 200º for 15 minutes
4. Move the temperature control from 200ºC to 0ºC. Let the oven
cool down for 20 minutes.
5. Move the AquaSmart function to 0. Wipe clean with a rag
or soft cloth.
GLASS DOOR PANEL
Do not use abrasive products which could damage the
glass. Remember that if the surface of the glass panel be-
comes scratched, it could cause a dangerous failure.
To simplify the cleaning, the inner glass panel can be taken
out of the door. The method for removing the glass from the
three types of door is shown below.
Door type A
After removing the screws fixing the glass, located on the
inner face of the door, lift the glass out carefully. In versions
with three glasses the intermediate glass can also be remo-
ved. The procedure is the same as above.
Door type B
After removing the screws fixing the upper support of the
glass, remove the support in direction "A". Then the glass
can be pulled out. In versions with three glasses the inter-
mediate glass can also be removed.
Door type C
Carefully lever up the glass with a flat screwdriver located
in the groove shown in the figure.
When refitting the glass, check that it is correctly fitted into
the toothed joint of the door and all around.
REMOVING THE DOOR FROM THE OVEN
To simplify cleaning the interior of the oven, the door can
be removed. The process of removing the door for the three
types is shown below:
Door type A
The hinges "A" have two moving bolts "B".
When the bolt "B" is lifted, the hinge comes out of its
housing.
Then close the door to the half-way position.
Next, lift the door upwards and remove it, sliding it out-
wards; hold the door by the sides close to the hinges when
doing this.
To replace the door, first slide the hinges into their grooves
and open the door completely.
Remember to turn the two moving bolts "B" used to engage
the two hinges before closing the door (Fig. 3).
WARNING
• Take care not to remove the hinge locking system when
taking off the door, as the hinge mechanism can spring back
suddenly.
• Never submerge the door in water for any reason.
A