Installation Notes - Cata 07042311 m Instrucciones De Uso

FITTING THE APPLIANCE (see Fig. 5)
These appliances are classified as Class I.
The earth is obligatory as provided for by law. The manu-
facturer declines all liability in the event that the accident
prevention rules have not been followed.
IMPORTANT
The adjacent piece or furniture or cupboard and all the ma-
terials used in the installation must resist a minimum tem-
perature increase of 85 ºC above the ambient temperature
during use of the appliance.
Certain types of vinyl or laminated kitchen furniture are
particularly susceptible to damage due to decolouration at
temperatures below those indicated.
If the appliance is installed without paying attention to this
temperature limit or if it is placed less than 4 mm from the
adjacent cupboards, liability will belong to the owner.

INSTALLATION NOTES

1. The oven has to be installed in a standard gap of 600mm,
as indicated in Fig. 5, whether under a hob or in a column.
2. On inserting the oven in a column, it is essential in order
to ensure there is enough ventilation, to remove the rear
panel of the furniture and have an opening of at least 85-
90mm as indicated in Fig. 5.
3. Check that the oven has been fixed securely in the housing.
Fixing the oven into the cupboard is done using 4 screws "A"
Fig.5. One in each corner of the oven door frame.
Fig. 5: Installation distanced for simple electric ovens of
60 cms wide (the shape of the upper casing may vary) and
attachment to the cupboard.
A. The support runner must be removed
B. Spacing of 75-90 mm between the wall and the rear part
of the support shelf and the base of the cupboard
C. Base
D. False box front to be assembled
Fig. 7: Ventilation and gap requirements for the installation
of e simple electric oven in a standard cooking unit.
Minimum ventilation requirements for upper, base and sup-
port shelves for the rear part of the unit.
A. Rear panel
B. Storage space
C. Remove the rear part of this section
D. Real panel
E. Storage space
F. Base
G. Minimum ventilation gap 80 cm2
Fig. 8: Ventilation and gap requirements for the installation
of a simple electric oven in an upper cupboard.