Electric Connections - RIB PRINCE 24V Manual Del Usuario

G G
B B
M
ECHANICAL STOP - OPTIONAL
Optional mechanical stop to stop closing, if the gate is not fitted with a floor
stop.
M
ECHANICAL STOPPER ADJUSTMENT
To adjust the stoppers you have to follow the scheme (Fig. 9).
To set the opening limit it's enough to fix the stopper (A) in the needed
position by tightening the 8mA screw with a n.13 key
To obtain the desired closing limit you must adjust the stopper (B)
(OPTIONAL) in the needed position and tighten it as for stopper (A).
M
AINTENANCE
To be undertaken only by specialized staff after disconnecting power supply.
Lubricate the hinges and check the oil level and thrust force generated by
the operator on the gate once a year.
Lubricate the nut screw with silicon grease every two years.

ELECTRIC CONNECTIONS

For connections and technical data of accessories refer to the appropriate booklets.
E
LECTRICAL SAFETY DEVICES
The installation must be installed according to the current regulations
and laws.
It is recommended that the following electronic control units be used:
- KS2 24V for 1 or 2 PRINCE 24V PLUS;
- K2 24V for 1 or 2 PRINCE 24V.
PRINCE has an adjustable deceleration system that slows down the
movement on approaching the travel limit, both when opening and when
closing. PRINCE 24V PLUS is normally connected to control units fitted with
an Encoder reader for the detection of obstacles. If an obstacle is
encountered during movement this operator goes immediately into reverse
so as to prevent any danger of crushing or dragging (as required by new
European regulations EN12453 and EN12445) without having to fit edge
sensors.
(Cod. ACG8088)
C
ONNECTION TO THE POWER SUPPLY
With PRINCE 24Vdc you must connect the blue and brown motors
wires to the plugs MOTORE1 and MOTORE2 of the control board (see
scheme on the page 21).
C
ONNECTION TO THE ENCODER
PRINCE 24V PLUS units are equipped with a built-in ENCODER to
connect to the electronic control boards (see scheme on the page 22).
8
9