Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
CABLE KINKS
Operator forcing the cable. Do not force the cable. Let the cut-
ter do the work.
Too much slack between machine and drain. Allow no more
than six inches between machine and drain.
Cable used in wrong size drain line. A cable that is too large or
too small a diameter for a line is more likely to kink.
FAILURE TO FEED
Frozen or worn rollers. Clean debris from around rollers. If roll-
ers do not turn, cable will not feed. Badly worn rollers must be
replaced.
Cable tangled in container. Do not retract end of cable into
feed rollers. Open container and untangle cable. Make sure to
use proper size cable for the job.
MOTOR DOES NOT RUN
Trigger in neutral (off) position. Switch Trigger to either For-
ward or Reverse.
10
TECHNICAL DATA
CAPACITY
VOLTAGE-FREQUENCY
POWER
CURRENT
NO LOAD SPEED
WEIGHT
1 1/4" - 3" (30 mm - 75 mm)
120 V ~ 60 Hz
450 W
3,2 A
(0 - 500) r/min
11,8 kg (26 lb)
Publicidad
Tabla de contenido
