Es - Instrucciones De Empleo; Mantenimiento - Kermi T. 10 Instrucciones De Montaje Y Empleo

Conditions of use
"VOB German Contract Procedures for Build-
ing Services".
stallations".
Observe the limitations for use in damp rooms
tors".
Use radiator only in closed heating systems.
Store and transport radiator only in the pro-
tective packaging.
tor and surrounding objects for air circulation.
Complaints
Please contact the supplier.
Disposal
Packaging and any parts that are not needed
should be recycled or disposed of properly.
Observe local regulations.
Technical features
•
•
Test pressure: 1.3 x operating pressure
•
•
Directions for installation
Protect radiator from damage
When installing, only remove protective pack-
aging at the fastening and connection points.
Only remove protective packaging completely
Fixing
Install mounting material according to sepa-
rate installation instructions.
Compact radiator connection
nated connection points.
Note: Do not install Therm X2
alternating connection: Install accompanying
®
Therm X2 separating plugs (see separate in-
stallation instructions).
-
-
-
-
-
®
separating plugs
plugs (top) and blanking plugs.
Only existing blanking plugs may be used on
Kermi steel panel radiators.
Valve radiator connection
manufacturer's data).
Air vent plugs (top) and blanking plugs are facto-
ry pre-assembled.
Radiators with two paint caps (FTV/PTV/PLV):
Remove paint caps from bottom on the valve
mountings and dispose of, as they must not be
used as seals on the radiator.
Radiators with four paint caps (FTP/PTP/PLP):
Remove paint caps from bottom on valve
mountings that connections are being made
and authorized for permanent operation.
NOTE: After removing the paint caps, check the
connections for any residue. If necessary, clean
the connections.
ES – Instrucciones de empleo
Uso previsto
de espacios interiores.
Uso indebido
El radiador no se debe utilizar como asiento ni
como medio para trepar o subir.
Advertencias de seguridad
ADVERTENCIA
¡Peligro de sufrir quemaduras!
Tenga cuidado al tocar el radiador.
CUIDADO
¡Riesgo de escaldadura durante la purga a con-
secuencia de salpicaduras de agua caliente!
Protéjase bien el rostro y las manos.

Mantenimiento

Purgue el radiador después de su puesta en
marcha y tras interrupciones prolongadas de
funcionamiento.
Utilice una llave de purga convencional.
value (see
V
5