Remote Channels - Metz MECABLITZ 50 AF-1 digital Manual De Instrucciones

Ocultar thumbs Ver también para MECABLITZ 50 AF-1 digital:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Remote groups
The slave flash unit can be assigned to one of three possible groups (A, B or C).
Each of these groups may consist of one or more slave flash units.
Setting the slave flash unit (mecablitz)
GROUP B
GROUP B
After approx. 5 seconds the indicator stops flashing and the setting is memori-
sed automatically.
After activation of the remote slave mode, "SL" appears in the display.
In addition, the slave group (GROUP) selected, the remote channel (CH) and the
reflector position (Zoom) are shown.
94
• With the remote slave mode activated,
press the button combination "Select" until
"GROUP" (= slave group) flashes in the
display.
• Use the + and — buttons to make the
required setting. Selection of group A, B
or C is possible.
The setting takes effect immediately.

Remote channels

To ensure that several remote systems used in the same room do not interfere
with one another, four independent remote channels (CHANNEL 1, 2, 3 or 4)
are available. Controller and slave flash units belonging to the same remote
system must all be set to the same remote channel.
Setting the slave flash unit (mecablitz)
• With the remote slave mode activated,
press the button combination "Select" until
"CH" (= remote channel) flashes in the
display.
• Use the + and — buttons to make the required set-
ting. Channel 1, 2, 3 or 4 can be selected.
The setting takes effect immediately.
After approx. 5 seconds the indicator stops flashing and the setting is memori-
sed automatically.
After activation of the remote slave mode, "SL" appears in the display.
In addition, the slave group (GROUP) selected, the remote channel (CH) and the
reflector position (Zoom) are shown.
2
CH
2
CH

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido