Installation; Important; Work Environment Conditions; Installing Add-On Modules - Corghi BRC1T-BR300 Manual De Uso

WARNING
The unpacking, assembly, lifting and installation procedures which follow should be
performed according to instructions. Failure to comply with these instructions could
damage the machine and put the operator at risk.
Remove the upper part of packing from the machine. Check the machine was not dam-
aged during shipping and identify pallet attachment points (fig.1a-b). At this point the
machine is ready for installation.
N.B. If the machine is equipped with add-on modules, refer to the section on Installing
additional modules.
WARNING
The place where the machine is to be installed must conform to applicable safety at
work regulations.
IMPORTANT: for correct, safe use of the equipment, users must ensure a lighting level
of at least 300 lux in the place of use.
WARNING
The machine must not be installed in an open area.
Move the machine to the designated installation site, respecting the minimum distances
reported in Fig. 3.
- Relative humidity: 30 ÷ 95% (without condensation)
- Temperature 0°C - +55°C
WARNING
The machine must not be operated in potentially explosive atmosphere.
WARNING
Position the unit at least 60 cm. from any heat source (Fig. 3).
Level the machine using the adjustable feet (5 fig.6).
Hook-up to the electric mains (see the section on "Electrical and Pneumatic hook-up").
Remove the left side panel (1 Fig. 6) on the BR base module. Slacken off the nuts under the
shoulder (2 Fig. 6) and rotate the plates (3 Fig. 6) 90° outwards and tighten firmly in place.
Position the add-on module over the base module, remove the feet (5 Fig. 6) and place
shoulder 4 over the plates (3 Fig. 6). Check alignment, then fix securely using the screws
provided. Fix with the 4 screws (6 Fig. 6) and the angle brackets (7 Fig. 6). Repeat the
operation for the other modules and fix the left side panel (1 Fig. 6) to the last module.
28

INSTALLATION

Work environment conditions

BR base module

Installing add-on modules

User manual BR