Sony YS-W170 Manual De Instrucciones página 9

7 VIDEO OUT A and B connectors (BNC-type)
Connect to the video input connector of a video
monitor, and output the video signal input to the
CAMERA IN connector. The A and B connectors
output the same signals.
8 75Ω (ON/OFF) switch
Controls the 75-ohm termination of the SYNC IN
connector.
• When using the SYNC IN connector only, set this
switch to ON.
• When using the SYNC IN and SYNC OUT
connectors, set this switch to OFF.
Note
If you are using neither the SYNC IN nor SYNC OUT
connector, set the switch to ON.
9 SYNC IN connector (BNC-type)
You can input external synchronization signals.
Notes
• Set the SYNC MODE switch 3 to SECONDARY to
synchronize the camera. (See "Connecting more than
one camera adaptor" on page 10 (GB) in the
Connection section.)
• If you connect multiple cameras that have different
synchronization methods, input the VS (or VBS)
synchronization signals.
0 SYNC OUT connector (BNC-type)
The signals output from the SYNC OUT connector
differ depending on the mode (PRIMARY/
SECONDARY) selected by the SYNC MODE switch
3.
PRIMARY: Outputs the synchronization signals
from the YS-W170/W170P (compatible with the
SYNC SYSTEM switch (VD/VS)).
SECONDARY: Outputs the synchronization signals
input to the SYNC IN connector.
Note
The external synchronization signals are not output
unless the camera adaptor is turned on.
qa AC IN connector
Connects to a 100 – 120 V AC outlet (YS-W170) or a
220 – 240 V AC outlet (YS-W170P).
9
(GB)