Connections; Notes On Connections; Operating With A Single Camera And Single Monitor; Connecting More Than One Camera Adaptor - Sony YS-W170 Manual De Instrucciones

Connections

Connections

Notes on Connections

• This unit will only operate when connected to a Sony
SSC-series camera or the SPT-M320/M320CE video
camera with multiplex transmission capability. When
making the connections, refer also to the operation
manual for the connected video camera module.
If you connect the unit to an older model of the SSC series,
please contact your Sony dealer.
• Turn off the power to all the equipment while making
the system connections. If you connect a camera to
this unit after switching the power on, the camera will
not be supplied with power.

Operating with a Single Camera and Single Monitor

Make all the connections before setting the POWER
switch of this unit to ON.
Video monitor
L Video signal flow

Connecting more than one camera adaptor

Using the synchronization signals from the YS-W170/
W170P or external unit allows you to synchronize the
cameras connected to second or more camera adaptors.
Notes
• If you connect multiple cameras that have different
synchronization methods, connect the VD camera to the
CAMERA IN connector on the first camera adaptor,
and connect the VIDEO OUT on the first camera
adaptor to the SYNC IN on the second camera adaptor.
• If you use the line lock camera for the external
synchronization signal source, you may not be able to
synchronize the cameras.
• If a number of YS series camera adaptors (except YS-
W270/W270P/W170/W170P) are used together, it
may be difficult to provide synchronization, depending
on how they are connected. In a case such as this, please
10
(GB)
• The cable connecting this unit to the video camera
carries the power supply and synchronization signal
in addition to the camera video output signal. It is
therefore not possible to add a booster or other device
between the unit and a camera.
• Always use a 75-ohm coaxial cable of the length
specified in the tables on page 8 (GB) when connecting
a video camera to this unit; use of an incorrect cable can
lead to camera malfunction. Also be sure to set the cable
compensation switch correctly.
[SYNC MODE:
PRIMARY]
(Front)
to VIDEO OUT
to video input connector
keep the following points in mind.
– Be sure to connect a YS-W170/W170P as the first
unit in the configuration, connecting the other YS
series camera adaptors in sequence, starting from the
second one. If there are more YS-W170/W170P
camera adaptors in addition to the first one, connect all
of the remaining YS-W170/W170P camera adaptors
together at the end of the sequence.
– At this time, set the 75Ω switch of the second unit
only to ON. Set the 75Ω switches of all of the other
units to OFF.
– If you have a VD synchronization camera such as
the SSC-DC310P, be sure to connect the YS-W170/
W170P first in the sequence, then connect the VD
camera's output (VIDEO OUT B) to the SYNC IN
of the second unit.
For more details on connection methods, see the next page.
Camera
to CAMERA IN
to DC IN.VS IN/VIDEO OUT
YS-W170/W170P
75Ω: ON
to an AC outlet