Skil 4690 Instrucciones De Funcionamiento Y Seguridad página 8

SM 1619X02137 03-07
The 4 position control wheel allows you to
control the function of the lights. Below, lists
the function of each setting (Fig. 1).
Setting 1: Turns OFF all lights.
Setting 2: Turns ON only the Laser light.
Setting 3: Turns ON both the Laser light and
the Site-Light.
Setting 4: Turns ON only the Site-Light.
The laser light guide is a class IIIA laser with a
maximum output power of 5.0m Watts and
conforms to 21 CFR 1040.10 and 1040.11.
TO ADJUST THE LASER LINE GUIDE
Use a flat head screwdriver to turn the
adjustment screw located on the side of the
laser module (Fig. 4). Turn on the laser light
guide by rotating the control wheel to setting
number 2. Rotate the adjustment screw until
the laser line is in the center of the blade.
There is no need to turn the tool "ON" while
adjusting the light beam.
The Laser line guide has a limited amount of
travel. Do not continue to turn the adjustment
screw after the line stops moving or if it
becomes significantly harder to turn the screw.
Overturning the adjustment screw may cause
the adjustment system to break or cause the
adjustment screw to fall out of the tool.
BLADE STORAGE COMPARTMENT
Your Jigsaw is equipped with a blade storage
area (Fig. 5) on the backside of your saw. To
open door, pull tab on door downward toward
the foot. To close door, lift door upward toward
the tool.
Be sure door is closed to prevent blades from
falling out.
BLOWER SWITCHED ON
For working with wood, plastic and similar
materials that produce large amounts of
sawdust (Fig. 6).
BLOWER SWITCHED OFF
For working with metals and when cooling
agents are used, or with dust collection
accessory (Not included, available as
accessory).
3/9/07 2:44 PM Page 8
USING THE LASER LINE GUIDE
Only turn on the laser light on when the tool is
on the workpiece.
1. First mark the line of cut on your workpiece
(good side down.)
2. Insert plug into the power source.
3. Place the front edge of the saw foot on the
workpiece, turn the 4 position control wheel to
setting 2 for laser light only or setting 3 for
laser light and site-light and align beam with
the line of cut .
4. Hold the tool firmly, squeeze the trigger and
allow the tool to reach desired speed.
5. Press down (to keep the saw foot flat
against the work surface) as you slowly push
the saw forward, keeping the beam in line with
the line of cut .
6. After completion of the cut, release the
trigger and turn off the laser light.
FIG. 6
-8-
FIG. 4
LASER LIGHT
ADJUSTMENT
SCREW
FIG. 5
BLADE
STORAGE
COMPARTMENT
DOOR
DUST BLOWER
LEVER