Inserting a capsule
• Push up the lever. The capsule holder will be
released and lowered slightly. (Fig. 10)
• Draw the capsule holder out of the coffee machine.
(Fig. 11)
• Insert the capsule into the capsule holdere (Fig. 12).
The capsule must be intact. Do not pierce or open the
capsule!
• Re-introduce the capsule holder into the coffee
machine and pull down the lever completely.
Making coffee
• Place a cup in the middle of the drip tray grating right
under the spout of the capsule holder.
• Press the button corresponding to the desired type of
coffee (Fig. 13).
• Once pressed, the button will start blinking, indicating
that the selected type of coffee is being prepared.
The coffee will flow into the cup.
• Once the selected type of coffee has been made,
the coffee selection buttons will illuminate again in a
steady manner.
• Push up the lever.
• Remove the capsule holder and turn it upside down
to remove the used capsule.
What to do after
• If no more cups of coffee are needed, press the ON/
OFF switch to turn OFF the machine.
• Insert the capsule holder without pulling down the
lever. This way, the capsule holder will not weigh on
the machine.
Fig. 10
Fig. 11
Fig. 12
Coffee selection buttons
Fig. 13