dirna Bergstrom bycool COMPACT 3.0 Instrucciones De Montaje página 23

COMPACT 3.0
Place console and centre equipment in the
13
most convenient place of cabin roof. Once
centred, remove console for later installation.
Fasten supports tightening nuts until outside
14
EPDM joint (Point 4a) of equipment is
compressed, between 3 and 6 mm; joint
EPDM must stay with a thickness of 19 and
22 mm.
Important: To avoid water from filtering inside
cabin, check EPDM joint tightening with
Compact base, as indicated on diagram.
3-6mm.
Cabin roof
Fasten selflocked nut until
EPDM gasket is
compressed between 3
14
and 6 mm.
Tighten (4) M8 nuts to support and (4) to Unit
15
base.
EPDM gasket
10 mm*
(*) (approx. after tightening)
Base
Support
23
Check compression
thickness using a
tape measure in the
four corners.
EPDM gasket
EN
®
14
15