Using The Lcd Monitor; Setting The Video Source; Cleaning And Maintaining The Lcd Monitor - Waeco PerfectView M511L Instrucciones De Montaje

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 44
_RV-511S.book Seite 30 Mittwoch, 15. März 2006 3:08 15

Using the LCD monitor

7
Using the LCD monitor
7.1
Switching on the monitor
If the monitor is switched off, press the "
monitor on.
The picture of the video source appears.
7.2
Switching off the monitor
/M
Press the "
" button (0 3, page 6) for longer than 2 seconds to switch the mon-
itor off.
The picture of the video source disappears.
7.3
Setting the monitor
To set the monitor to suit your requirements, proceed as follows:
With the monitor switched on, briefly press the "
the required parameters.
The parameters are displayed in the following sequence:
Brightness
Colour
Contrast
Tint
Volume
Press the button (0 2, page 6), to reduce the value of the selected parameter.
Press the button (0 3, page 6), to increase the value of the selected parameter.
7.4

Setting the video source

If you wish to switch to a different video source (from video 1 to video 2), press the
"V1/V2" button (b 10, page 7) on the remote control or the monitor (0 5, page 6).
The monitor switches from video source 1 to video source 2 and vice-versa.
If you have connected the green cable to the reversing light and a voltage is
present, video source 2 is activated automatically.
8

Cleaning and maintaining the LCD monitor

Caution!
Do not use sharp or hard objects for cleaning as these may damage
the monitor.
Remove the cable before cleaning the monitor to prevent short circuiting.
Clean the monitor with a soft, damp cloth from time to time.
30
/M
" button (0 1, page 6) to switch the
/M
" button (0 1, page 6) to set
PerfectView M511L

Publicidad

Tabla de contenido
loading

Tabla de contenido