Using The Lcd Monitor - Waeco PerfectView M70L Instrucciones De Montaje

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 43
_RV-70.book Seite 28 Freitag, 15. Dezember 2006 4:15 16

Using the LCD monitor

Note
I
If voltage is present at the white cable (10), video input V2 is automatically
activated.
The white cable (10) is a signal line for activating a side-view camera when the indi-
cator is actuated.
If necessary, connect the DIN socket (7) of the connection cable to the DIN plug
of video source 1 (e.g. camera).
If necessary, connect the DIN socket (8) of the connection cable to the DIN plug
of video source 2 (e.g. DVD player).
7
Using the LCD monitor
7.1
Switching on the monitor
When the monitor is switched off, press the "M" button (fig. 0 1, page 6), to
switch it on.
The picture appears.
7.2
Switching off the monitor
Press the "M" button (fig. 0 1, page 6) for at least two seconds to switch the
monitor off.
The picture disappears.
7.3
Adjusting the monitor
To set the monitor to suit your requirements, proceed as follows:
Press the "M" button (1), to set the required parameters.
The parameters are displayed in the following sequence:
– Brightness
– Colour
– Contrast
– Volume
– Return
Press the "–" button (2) or the "+" button (3) to move the cursor
parameter.
Press the "M" button (1), to activate the required parameter.
The current parameter value is shown, for example Brightness:
Press the "–" button (2) to reduce the value of the selected parameter.
Press the "+" button (3) to increase the value of the selected parameter.
28
, page 6
(fig. 0
)
PerfectView M70L
to the required

Publicidad

Tabla de contenido
loading

Tabla de contenido