Using The Monitor; Setting The Monitor; Cleaning And Maintaining The Monitor - Waeco MOBITRONIC M45R Instrucciones De Montaje Y De Uso

_M45.book Seite 35 Freitag, 21. November 2008 11:05 11
M45R
Note
I
If voltage is present in the brown cable, the monitor is switched on automatically
and the camera is activated.
➤ Connect the white cable to the positive cable of the instrument panel illumination (6).
8

Using the monitor

8.1 Switching the monitor on and off (fig. b, page 7)
➤ Switch the ignition on.
➤ Switch the monitor on by pressing the ON/OFF switch (1).
✓ The picture appears.
Note
I
If you have completely connected all of the monitor cables, the brightness
should be automatically reduced when the driving lights are switched on.
➤ Switch the monitor off with the ON/OFF switch (1).
✓ The picture disappears.
➤ When the ignition is turned on, the monitor should switch on as soon as reverse gear
has been selected.
➤ Switch out of reverse and the system switches back to stand-by.
8.2

Setting the monitor

➤ Set the brightness and contrast as required.
The inverter is located on the rear of the monitor (blue dip switch, fig. b 5, page 7) for
normal or inverted display on the monitor. With the inverted display, the monitor acts as
though you were looking in the rear-view mirror of your vehicle.
MIRROR dip switch in bottom position:
MIRROR dip switch in top position:
➤ Decide which type of display you want and switch the dip switch into the required po-
sition.
9

Cleaning and maintaining the monitor

Caution!
e
Remove the cable before cleaning the monitor to prevent short circuiting.
Caution
a
Do not use sharp or hard objects or cleaning agents for cleaning as these may
damage the device.
Inverted display
Normal display
Using the monitor
35