Bosch CCS180 Instrucciones De Funcionamiento Y Seguridad página 15

2610052972.qxp_CCS180 8/6/19 12:50 PM Page 15
▶ Rip Cuts
The combination blade provided with
your saw is for both cross cuts and rip
cuts. Ripping is cutting lengthwise with
the grain of the wood. Narrow rip cuts
are easy to do with a rip fence (Fig. 14).
To attach optional rip fence, insert
fence through slots in foot to desired
width as shown and secure with the
knob.
fence, be sure the rip fence does not
touch or interfere with the free
movement of the lower guard or
contact the saw blade.
▶ Rip Board Guide
When rip cutting large sheets, the rip
fence may not allow the desired width
of cut. Clamp or nail a straight piece of
1" (25 mm) lumber to the sheet as a
guide (Fig. 15). Use the right side of the
foot against the board guide.
▶ Service
Preventive maintenance performed by
un au thorized personnel may result in
misplacing of internal wires and
components which could cause serious
hazard. We recom mend that all tool
service be performed by a Bosch
Factory Service Center or Authorized
Bosch Service Station.
▶ Batteries
Be alert for battery packs that are
nearing their end of life. If you notice
decreased
significantly shorter running time
between charges then it is time to
Operating Instructions
After attaching or
adjusting the rip
Maintenance
To avoid accidents, always disconnect battery pack from tool before
cleaning or performing any maintenance.
NO USER SERVICE-
ABLE PARTS INSIDE.
tool performance
Fig. 14
KNOB
RIP
FENCE
Fig. 15
RIP
BOARD
GUIDE
replace the battery pack. Failure to do
so can cause the tool to operate
improperly or damage the charger.
▶ Tool Lubrication
Your Bosch tool has been properly
lubricated and is ready for use.
▶ D.C. Motors
The motor in your tool has been
engineered
dependable service. To maintain peak
efficiency of the motor, we recommend
it be examined every six months. Only a
genuine Bosch replacement motor
or
specially designed for your tool should
be used.
-15-
DESIRED
WIDTH
OF CUT
DESIRED
LINE
OF CUT
for many hours of